(04-154) PoE Lock Controller

The Borer PoE Lock Controller can control one or two doors. The PoE Lock Controller works with third part PoE Switches (Cisco, HP, etc.) to accept power and data over up to 100 meter length of CAT 5 /6 cable. It allows the installer to establish airlocks and mantraps out of two interlocking doors without having to employ third party add on products.

Description

The Borer PoE Lock Controller can control one or two doors. The PoE Lock Controller works with third part PoE Switches (Cisco, HP, etc.) to accept power and data over up to 100 meter length of CAT 5 /6 cable. It allows the installer to establish airlocks and mantraps out of two interlocking doors without having to employ third party add on products.

The PoE Lock Controller can also be powered from a local 12 Volt DC power supply or can be powered from a 48 Volt PoE compatible Power Injector. By combining a Power Injector and a PoE Switch a low cost battery back-up solution can be configured.

PoE Lock Controller Features:

  • Support for one or two doors each with a powered lock and one or two card readers.
  • Power over Ethernet Powered Device (PD) IEEE 802.3at compliant to accept 48 Volts DC power down a standard network cable.
  • Support for local 12 Volt DC power input.
  • Protection for short circuit, polarity reversal and accidental connection to a non-compliant PoE circuit.
  • Two solid state lock outputs that intelligent deliver power to locks reducing energy levels once the lock is engaged.
  • Support for fail safe (power to lock) and fail secure (power to unlock) locks.
  • Monitor circuits for door forced open, door open too long, lock compromised, tamper and two press-to-exit buttons.
  • Supervised inputs with four state monitoring.
  • Quick press fit cable terminations for ease of installation.
  • Reprogrammable so that firmware updates can be automatically downloaded directly to the lock manager over the LAN.